注意：COB灯带发热量很大，建议不要在无人看管时使用，可以尝试用普通灯带或少量灯珠代替。

CAUTION: COB LED make lots of heat, this light should NEVER be left unattended

制作这一台灯需要三条20cm左右的灯带，一个触摸灯控（触摸感应铜箔直径1.5cm），一些导线、胶带和焊接用的烙铁。

To make this model ,you need three 20cm COB LED belt (60cm in total), one led controller with touch sensor (1.5cm diameter), some wire, tape, and soldering iron

首先，你需要如图焊接灯控和灯带，此图仅供参考，如果您使用的型号有其他需求，请务必注意。

First, solder the LED belt in series, then connect them to led controller

第二步，把灯带和控制器从外向内穿过底座的孔洞

这个洞大小不够USB接口穿过，所以只能从外向内穿，或者你也可以选择有更大开孔的“base for USB”这一版，但我没测试过:D

Secondly,thread the belt and cable through the hole in the base

the hole is not big enough to let USB port go trough,so you should thread them from outside to inside, or you can choose the model “base for USB” which has a bigger hole (I haven't test this version,so if you meet some trouble,tell me please :D.

如图组装触摸按钮（可能要用到胶水）

Assemble the touch button (may need some glue)

把灯带粘到立柱上，立柱最好用abs或者其他耐温材料打

Stick LED belt to the supports

LED makes lot of heat,so print it with ABS if it's possible

把底座的盖板扣上（图中左下角那块）

底部设计有绕线位置，图中这版效果不好，上传的模型已经改进过了

close the coverplate for a better look (the small part in the left bottom corner of photo)

and there are some space for cable on the bottom (this version dosen't work very well,but i have improved it)

最后组装“烟“和火箭

Finally, assemble the smoke and rocket

最好使用可调亮度的灯控，否则立柱可能会在高亮度时快速变形。

I really suggest u to use a controller which can adjust brightness,to let the lamp work for longger time and stay low temperature