I searched long and far for a good curved katana/sword, but I could not find one. Then I stumbled apon a nice one on Printables. So now it is Makerworld-ified! Please use 0.4mm
Good! However next time, and for everyone else, I recommend 100%. Because it's proven slower is stronger, and because it's vertical, its fairly weak. However, use PETG-CF like I did, or maybe next time i'll do polylite pc for EXTRA layer adhesion
Hi. I personally experience problems, so I don't mean to blame you, but could you try flow calibration and pa calibration. Knowing you are resonable, I don't expect a reprint from you. However, I would suggest adding a thin layer of tape on the ends to make it slightly wider. do this when the blades are out by taking off the cap.
Hello everyone, I am the poster of this file. I have only printed one of these before myself with a 0.8mm nozzle, and it did not fit. However, I am proud to say I am willing to print this once again! PETG-CF blades and a PLA handle seems like the option for me.