This screw cap was made to cover the IKEA Bror Shelves hole.

I'm not sure if it'll fit in the utility cart but would love to hear if anyone tried.

This was tested on two different IKEA Bror Shelves.

Instructions:

I designed it so you can screw in the cap, it is a bit snug to get the first bite but once it gets in; it works well!

or

You can also treat it like a snap connector and push it in. I didn't use a snap connector because I find those break due to the nature of how small it needs to be to fit in the hole but willing to try again in a later revision if there are interest.

Hardware:

Printer: Bambu Lab A1 with AMS Top Mount

FIlament: eSUN PLA+ Black

Slicer: Bambu Studio

Nozzle: Bambu Lab A1 0.4 nozzle

Plate Type: Bambu Lab Textured PEI Plate

Profile: Stock 0.20mm Strength @ BBL A1