Please rate the print profiles - It would help tremendously.
Have a rounded box for your stuff - now the box itself says what's inside.
Use the customizer (see customize button above!) or OpenSCAD to adapt the text and sizes as needed!
You can print the box without supports:
This version III now allows to enter the angle at which the box sweeps upwards from the print bed. By default its 55 degree, so it should print fine without supports on most printers. If you choose an angle of 90 degrees, its like the version II, harder to print, but a bit bubblier.
Note that the wiggle room between the top lid and the bottom container is by default zero. If your printer is not well calibrated, increase this value to e.g. .3mm, so the lid fits on the bottom container.
If you print the top lid separately and stop the print at .85mm and change the filament color, you will have the text on top nicely readable. (As in the pictures posted above)
If you like it, please have a look at all my customizable creations.
There are configurable-text-based creations, fidget rings, and more!
E.g. there are keychains available, the keychain name tags
the chain of letters
the chain of letters
Or the sweeping text
Also check out the working print in place cannon etc.
Have fun!