Oil seal (WD40) for rods
Copyright Claim
Oil seal (WD40) for rods
Boost
72
117
14
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
17 min
1 plate
PLA, 0.2mm layer, 2 walls, 15% infill
28 min
1 plate
Boost
72
117
14
4
115
72
Released
Description
Avoid spraying lubricant everywhere every time you apply WD40 to your printer
Comment & Rating (14)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
very useful to avoid getting dirty
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
take care, standard WD40 lasts only hours, not even days for lubricating
0
Reply
yes, because standard WD40 is not a lubricant but a rust remover.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivatives
© 2024 MakerWorld