This holder is intended to be used as a replacement for the original spool holder or as an added option. It can be mounted to any IKEA Skadis board. Compared to the original holder it accomodates spools ranging from 250g to 1kg or more if the spool is no wider than 78mm. Amazon Basics spools will fit.
The holder is printed in two parts to maximize strength and minimize friction between the holder and the spool. The assembly of the part is dead simple, just slide the low friction sleeve over the holder until it snaps into place. This can be done from the front or the top. See the images for comparison. Depending on the material used for the print, you might want to add some glue between the holder and the sleeve. For a permanent installation I recommend using my IKEA Lock Plug to further secure the holder.
I use the holder in connection with my P1P that I semi-enclosed with IKEA Skadis boards. The adapters can be found here:
I used Meta PLA from Jayo as it has a very shiny finish reducing the friction even more. Regular PLA, PETG etc. will work just as good though. Stay away from weaker materials like Silk-PLA or once with a matte finish. The main part (the holder) should be oriented like it would when hanging. The sleeve should be place on its front side. The middle hook needs a small support:
I am constantly developing more IKEA Skadis attachments. Check out my
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.