I went back into Hueforge and adjusted color order and layers, it came out nice.
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
The Model is 159.6x240mm in size
You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 2.2mm and the Actual Depth is 2.2mm
Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA BambuLab Basic Red Transmission Distance: 4
PLA BambuLab Basic Gray Transmission Distance: 2
PLA BambuLab Basic Jade White Transmission Distance: 5
This print uses 4 unique filaments
Swap Instructions:
Start with Black
At layer #10 (0.88mm) swap to Red
At layer #16 (1.36mm) swap to Gray
At layer #19 (1.6mm) swap to Jade White for the rest.
its even better that way ,than original, just open it and was exact like the description, but yes you can swap them if you like, like most of my things,. but no many do it