Rod Caps
Copyright Claim
Rod Caps
Boost
120
216
41
Print Profile(1)
0.2mm layer, 6 walls, 25% infill
Designer
29 min
2 plates
Boost
120
216
41
7
295
228
Released
Description
I couldn't find a Rod Cover that fits perfectly in my new Bambulab P1S, so I decided to create my own quickly. The right rod in my printer has a slight bump, but all existing models are flat, causing them to sit imperfectly and wobble. With this simple design, that problem is eliminated.
I included three different sizes to print simultaneously, taking less than 10 minutes, allowing you to find the best fit possible.
I opted for the middle size (19.3mm), and it snapped perfectly with a satisfying click.
Check out my bottom rod cover design here: Bottom Rod Cover on MakerWorld.
Comment & Rating (41)
All
Print Profile
0.2mm layer, 6 walls, 25% infill
Great but dont see the nead for 6 of them
The designer has replied
0
Reply
It's simply a matter of different tolerances, depending on your printer calibration and Bambulab's manufacturing process. The first two (on the left) measure 19.15mm, the middle one is 19.30mm, and the ones on the right are 19.45mm.
So you can find the best fit for your printer.
(Edited)0
Reply
Replying to @dmytrodpo
oh sorry i didn’t read the description. was a quick print
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
verry nice Model
(Edited)
The designer has replied
0
Reply
Thank you
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
Used the 19,3mm caps, they snapped on nice.
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
printed mid one good
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
Nice Print! Thanks for including different sizes!
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
exactly what I needed
(Edited)
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
There is a little trial and error needed with the sizes but it does the trick
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
Super passgenau
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
great
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
Great.
0
Reply
License
This work is licensed under a
Creative Commons AttributionRelated Models
© 2024 MakerWorld