Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
The Model is 100x100mm in size
You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 2.2mm and the Actual Depth is 1.2mm
Filaments Used:
PLA Overture Black Transmission Distance: 0.7
PLA Overture White Transmission Distance: 4.4
PLA PolyLite Grey Transmission Distance: 1
This print uses 3 unique filaments
Swap Instructions:
Start with Black
At layer #7 (0.64mm) swap to White
At layer #13 (1.12mm) swap to Grey for the rest.
This is the first hueforge I made I thought it turned out amazing, I was not expecting it to look like this. I hope you like it as much as I do! If you did print this please leave a review and make.