I hereby offer you a HueForge I made, which turned up super nice I would say.
Here stands mighty Kratos, in his prime and glory. Well, he's always in his prime, but here's a bit younger. Enjoy printing it!
And if you like the result, please give a like :) .
Object can be scaled freely, but never forget to keep Z height at 1.60 - Do not alter this value!
Also, from other's words of wisdom, you may have a better quality if you rotate to 315 degrees on the Z axis on bambu printers (lines will be perfectly parallel and not diagonal).
My print was done at a scale of 70% to better fit the plate of my X1C.
Printing must be done at a layer height of 0.08.
Filaments Used:
Generic PLA Black Transmission Distance: 0.3
Generic PLA Red Transmission Distance: 2
Generic PLA Gray Transmission Distance: 2
Generic PLA Basic Jade White Transmission Distance: 2
This print uses 4 unique filaments
Swap Instructions:
Start with Black
At layer #4 (0.4mm) swap to Red
At layer #8 (0.72mm) swap to Gray
At layer #16 (1.36mm) swap to Jade White for the rest.
For instructions on best settings for HueForges, follow this link - https://wiki.bambulab.com/en/filament-acc/filament/hueforge-printing-guide .