Sometimes you need to write something and you don't have a pen, well TAKE A PILL THEN.
Always have a pen whith you in this little form factor that expands into a pen.
You can also print the KEYCHAIN BODY to make it a useful keychain!!
Super Easy Assembly steps:
1.
You will need a BIC pen and something to cut the ink cartridge, (if you use one that is almos empty it is better)
2.
Cut the ink to length.
You can add a little dab of silicone to end of the ink to prevent it from flowing out.
3.
Inset it into the INK HOLDER
Join the three sliding parts together as shown.
4.
Join the PEN BODY to the sliding parts (IT IS A SNAP FIT SO IT SHOULD CLICK IN)
5.
PUT THE CAP AND YOU ARE DONE, ENJOY YOUR PILL!!
(please do NOT try to swallow this)
Follow me on:
Instagram: https://www.instagram.com/afo3d/
TikTok: https://www.tiktok.com/@afo3d
Youtube: https://www.youtube.com/@AFO3D
If you wish to sell any of my files subscribe: https://patreon.com/AFO3D
Reccomended Print Settings:
- Brim
- 0.4mm nozzle
- Some parts require supports (PILL BODY, PILL CAP, KEYCHAIN CAP)
-AFO