Slim Wallet (V3) - print in place
Slim Wallet (V3) - print in place
Boost
475
675
70
Print Profile(2)
0.15mm layer, 2 walls, 7% infill
Designer
2.5 h
1 plate
0.15mm layer, 2 walls, 7% infill
2.6 h
1 plate
Boost
475
675
70
34
1.2 k
846
Released
Description
Updated Version available (V4):
https://makerworld.com/en/models/485576#profileId-398072
---------------------------------------------------------------------------------------------------------------
A print-in-place slim wallet that offers space for 7 cards and a drawer for cash.
I looked for a long time for a wallet that had enough space for cash, but I couldn't find one so I made this one myself.
This ist the Updated Version of Slim Wallet (V2)
- Now its print-in-place so you have to print only two parts and dont have to stop the print
- I added a lever to securely open and lock the cards so that they don't fall out
- I reworked the drawer mechanism so that it lasts better
Have fun with it and leave a like or subscribe if you like it!
If there are any suggestions for improvement, feel free to write a comment.
Comment & Rating (70)
All
Print Profile
0.15mm layer, 2 walls, 7% infill
Great for storing unused credit cards. The only thing that is missing is to have a stop to avoid the drawer falling off, similar to the bump that locks it in the closed position.
3
Reply
Print Profile
0.15mm layer, 2 walls, 7% infill
good
1
Reply
mate, the tray should be put the other way around so it would snap in
0
Reply
Boosted
Print Profile
0.15mm layer, 2 walls, 7% infill
I've finally found a perfect wallet! Version 2 didn't work for me but this version is perfect. Thanks for the great design.
2
Reply
Very nice, works perfectly!
0
Reply
fun idea, but not very slim.
0
Reply
Boosted
Print Profile
0.15mm layer, 2 walls, 7% infill
Works just as it's says, took me a second to figure out that I put in drawer backwards and upside down but worked that way too.
0
Reply
Print Profile
0.15mm layer, 2 walls, 7% infill
Overall I am satisfied with this design only thing was that it is a bit rugged around the edges the first time I printed it but then I went to 50% speed and the corners look better. I did take some advice and used matte black, wich looks great! thanks for the design!
0
Reply
Print Profile
0.15mm layer, 2 walls, 7% infill
Great quality and useful had a mess up on the corner but I think that's on my end
0
Reply
Print Profile
0.15mm layer, 2 walls, 7% infill
lock button was a little sloppy, but otherwise great.
0
Reply
Print Profile
0.15mm layer, 2 walls, 7% infill
cool
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld